Figure 1. Pressurized nitrogen gas is injected into a melt to penetrate the part via a network of thicker cross-sectioned gas channels (click to enlarge). Gas-assist injection molding was developed ...

Significant amounts of residual oil can remain trapped after primary and secondary recovery stages, which can be effectively recovered using tertiary gas injection processes. While tertiary gas ...

In an attempt to bring a new level of consistency to gas-assist molding, Ferromatik Milacron has developed Airpress III, a patented system that modifies resin injection and delays the timing for the ...

Typically, a well will produce at its highest production rate at the beginning of the production cycle; and then production will wane. In an effort to increase production from both oil and natural gas ...

Gain Technology displayed an automotive IP core half that used its GAIM systems to economically reduce the use of expensive hot-runner manifolding in the tooling for the part. Fluid-assist injection ...

The original acid-gas injection project near DCP Midstream’s Artesia, NM, gas plant started up in November 2003 and consisted of drilling an injection well and installing an acid-gas injection ...